mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Cab Heater and Air Conditioner, Valeo 83.00 Troubleshooting A/C Clutch Circuit Tests for Diagnosing No A/C Clutch Engagement Test Conditions Test Point/Method Good Result What to Do if Test Fails A/C request input key on, engine on ServiceLink/Datalink Monitor A/C request is received by the BHM Perform the "Evaporator Probe Circuit Tests." air selection switch in one of A/C settings NOTE: Make sure the Datalink Monitor template is not in Test Mode. The control head should request A/C. This will cause the "A/C Request" annunciator on the template to indicate that the request is on.

If the annunciator does not indicate that a request for A/C is received, check the settings on the control head before proceeding with "What to Do if Test Fails." Check wiring between the control head and the bulkhead module. Check for an open circuit. fan (blower) speed on any setting but off connect ServiceLink and use the "A/C Clutch Function" Datalink Monitor template to see if the A/C request is seen by the BHM Check the control head. Check the bulkhead module. Try to manually ground the A/C request input while observing the template to confirm. A/C clutch circuit * key on, engine off ServiceLink/Datalink Monitor A/C clutch should engage Check continuity across the binary switch.

If the circuit is open, check if the refrigerant pressure is within operating range of the binary switch. (Refrigerant pressure may be very low or too high.) If pressures are okay, replace binary switch. connect ServiceLink and use the "A/C Clutch Function" Datalink Monitor template to manually actuate the A/C clutch output NOTE: Put the template in "Test Mode" and actuate the A/C clutch by selecting the button for "Clutch On." You should hear a distinct click when the clutch engages. The A/C clutch annunciator (BHM to clutch) should turn on when the output is energized.

If this annunciator indicates that the output is on but the clutch does not engage, then the problem is in the A/C clutch circuit and not with the BHM. If the A/C clutch annunciator does not indicate that the output is energized when the output is turned on and the clutch does not engage, then the problem is with the BHM. Check for faulty wiring. Check for faulty A/C clutch ground circuit. Check for faulty A/C clutch coil (coil resistance should be 3 Ω ±0.5 Ω ). Check for faulty BHM (see note in Test Point/Method column). * Circuit faults with the A/C clutch output may generate bulkhead module fault codes.

Table 10, A/C Clutch Circuit Tests for Diagnosing No A/C Clutch Engagement Backlighting Circuit Tests Test Conditions Test Point Good Result What to Do if Test Fails backlighting circuit ground test battery switch on (if equipped) Measure between pin B8 of the control head connector and the positive battery post. 12V * Check for an open in the control head ground circuit. key off, engine off control head connector disconnected Business Class M2 Workshop Manual, Supplement 13, March 2008 300/17