Work Mode 1. When the starter switch is turned "ON" the work mode is automatically defaulted to "Digging Mode." 5 6 7 2. Select the work mode using button (2, Figure 46) before starting work. 3. When the work mode button (2, Figure 46) is pressed, a signal sounds, changing the work mode to either "Digging Mode" or "Trenching Mode." When the trenching mode is selected, the LED indicator (6, Figure 46) turns "ON." When the digging mode is selected, the LED indicator (6, Figure 46) turns "OFF." 1 2 3 4 ARO0480L Figure 46 4. When the trenching mode is selected, the control valve is set to optimum condition for trenching work. Auto Idle Mode 1.
The system will automatically reduce engine speed to idle speed approximately 4 seconds after all of the control levers are in the neutral position. As soon as a pilot function is activated, engine speed is automatically returned to the preselected range. 2. When the starter switch is turned "ON," the work mode is automatically defaulted to "AUTO IDLE." 3. When the LED indicator (7, Figure 46) is turned "ON," the auto idle function is activated. Deactivate the auto idle function by again pressing the auto idle selector button (3, Figure 46). At this time the LED indicator will be turned "OFF." WARNING! Turn "OFF' auto idle function when performing work in close operating area, i.e.
work in a narrow area and loading / unloading on or off a trailer. 022-00058E Operation and Maintenance Manual Operation 3-23 Mode Selection Point Future of Control DIGGING MODE General excavation. Loading dump trucks. Lifting and transport of heavy objects. Breaker. General standard. TRENCHING MODE Trenching. Excavating of side wall. Required to constant swinging. The swing is faster and stronger than boom or arm.