5. If the level is below "L" mark add oil. A. Shut down engine. B. The hydraulic tank is pressurized. Turn the breather cap slowly to allow the pressurized air to vent. C. Remove the upper cover of the hydraulic tank and add oil. IMPORTANT Do not fill above "H" mark on sight gauge. Overfilling can result in damage to equipment and oil leaking from hydraulic tank due to expansion. Figure 16 6. If oil level is above the "H" mark drain oil. A. Shut down engine and wait for the hydraulic oil to cool down. B. Drain the excess oil from drain plug (Figure 17) at the bottom of the tank into a suitable container. NOTE: Dispose of drained fluids according to local regulation.
CHECK FOR LEAKS IN HYDRAULIC SYSTEM Figure 17 1. Perform a daily walk-around inspection to make sure that the hoses, piping, fittings, cylinders and hydraulic motors are not showing any signs of leakage. If any is noted, determine the source of the leak and repair. 4-14 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual