CHECK WATER SEPARATOR AND DRAIN WATER AS REQUIRED 1. A water separator is inside the right side access door. 2. Open the access door on right side of the machine. 3. If red ring in bowl reaches level line, loosen plug (Figure 20) at bottom of body and drain water into a suitable container. NOTE: Dispose of drained fluids according to local regulation. 4. Tighten plug (Figure 20) and prime fuel system. (See page 4-38) Figure 20 5. Close access door. CHECK OIL LEVEL OF SWING REDUCTION DEVICE WARNING! The gear oil is very hot after the machine has been operating. Shut all systems down and allow them to cool.
Before fully removing any motor case inspection port plug, etc., loosen the plug slightly to allow pressurized air to escape. NOTE: When checking level using a dipstick always remove and wipe it clean before making final level check. 1. Remove dipstick (1, Figure 21) and wipe the oil from the dipstick with a cloth. 2. Insert dipstick (1, Figure 21) fully in the guide. Figure 21 4-16 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual