3. When dipstick is pulled out, oil level must be between "HIGH" and "LOW" marks on dipstick. NOTE: If oil is above "HIGH" mark on dipstick, some must be drained to proper level. 4. If the oil does not reach the "L" mark on the dipstick, add oil through fill port (2, Figure 21). 5. If the oil level exceeds the "H" mark on the dipstick, remove drain plug (Figure 23) and drain the excess oil into a suitable container. Figure 22 NOTE: Dispose of drained fluids according to local regulations. Figure 23 CLEAN DUST NET IN FRONT OF OIL COOLER IMPORTANT If running excavator in dusty area, check dust net everyday and clean it if dirty. WARNING!
Figure 24 If using compressed air or water to clean the dust net, make sure that proper eye protection is worn. 1. Loosen the wing nut(s) and remove dust net. 2. Clean with compressed air or a water. 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-17