CHECK COOLING SYSTEM AND REFILL AS REQUIRED WARNING! Allow the engine to cool before releasing the radiator cap. Make sure to loosen the cap slowly to release any remaining pressure. Radiator cleaning is performed while the engine is running. Take extreme caution when working on or near a running engine. Make sure to lock out and tag the controls notifying personnel that service work is being performed. Do not remove the radiator cap unless it is required. Observe the coolant level in the coolant recovery tank. 1. When the engine is cold, remove the radiator cap and check the coolant level inside the radiator. Do not rely on the level of coolant in the coolant recovery tank.
Refill radiator as required. Refer to coolant concentration table. (See page 4-63) 2. Check to make sure that the coolant transfer line from the coolant recovery tank to the radiator is free and clear of obstructions, or not pinched. 3. Observe the level of coolant in the coolant recovery tank. The normal cold engine fluid level should be between "FULL" and "LOW" marks on tank. Figure 25 4. If the coolant is below the "LOW" mark, add coolant to this tank. CHECK LEVEL OF WINDOW WASHER LIQUID 1. Open right front door and check fluid level in windshield washer tank. 2. Open fill cap and add fluid. NOTE: Use a washer liquid that is rated for all seasons.
This will prevent freezing during cold weather operation. Figure 26 4-18 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual