10. Fill the hydraulic oil tank. Check level using sight gauge on side of tank. 1 2 11. Place spring (3, Figure 80) on rod (4) and assemble cover (2). 12. After replacing and cleaning the hydraulic oil, filter and strainer, vent the system. See “Venting and Priming Hydraulic System” on page 4-71. 3 IMPORTANT 4 When the hydraulic breaker is being used, due to the higher heat generated by this unit, use replacement intervals recommended under the “Hydraulic Oil and Filter Service Intervals” on page 3-36. 5 13. Check level of hydraulic oil tank. (See page 4-13) 6 ARO1720L Figure 80 4-48 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual