Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REMARK Steps 6 to 8 are identical with those in "CHANGE OIL IN TRANSMISSION CASE (PAGE 4-65)". NOTICE in the brake oil tank. 4 - 68 Do the not start up the engine without the tra engine is started up while the transmi transmission hydraulic pump will suffer d 6. Before starting the engine, add 9 0 liters (23.78 US gal) of oil through oil filler port (F). When oil is added, the level will t emporarily go above the oil level on sight gauge (G), but any abnormality. le. 7. Start the engine and run at low id 8.

Add oil through oil filler port (F) u ntil the oil level is between the H and L marks on sight Make sure that the oil level in the brake oil tank does not go down below the mark in the the engine is running at low idle. I f the oil level goes down below (H) mark, stop the engine REMARK Steps 9 through 11 are identical with those in "CHANGE OIL IN TRANSMISSION CASE (P 9. Perform the warming-up operatio n of the engine until the torque converter oil temperatu 40°C (104°F). 10. When the torque converter oil te mperature gauge rises to 40°C (104°F), bleed the air fro Front brake: See "BLEED AIR F ROM FRONT BRAKE (PAGE 4-32)". FROM CENTER BRAKE (PAGE 4-33)". Center brake:

See "BLEED AIR NOTICE D o not attempt to use the oil drained d uring air bleeding again. Such a practice can cause damage o e quipment. M ake sure that the oil level in the brak e oil tank does not go down below (H) level in the sight gauge d oes, the brake oil pump could be dam aged.