. MAINTENANCE SERVICE PROCEDURE that it reaches the (3) Center hinge pin (2 places) (4) Tension pulley (1 place) NOTICE Do not use air pressure or oil pressure to perform high-pressure greasing. 4 - 69 11. After fi stop the engin 3 specifi ed level. F or details, see " CHECK OIL LEVEL IN TRANSMISSION CASE, ADD LUBRICATION 1. By usi ng a greas e pump, pump in grease through grease 2. After g reasing, w ipe off any old grease th at was pushed out. Perform th e greasing operation every day whe n operating in places where the grease flows o ut easily, such as when traveling th rough mu d or water. (1) Transmission fro nt mount (1 plac (2) Transmission rea r mount (1 plac