Kubota — 4.1 Checking brake pedal free travel

PERIODIC SERVICE EVERY 100 HOURS 3. Replace the air cleaner primary element: Once every 1000 hours or yearly, whichever comes first. 2. Apply moderate thumb pressure to belt between pulleys. 3. If tension is incorrect, loosen the tension pulley mounting nut and turn the adjusting bolt to adjust the belt tension within acceptable limits. NOTE : Check to see if the evacuator valve is blocked with dust. IMPORTANT : Make sure that the V-belt tension is as specified as shown in the table above after tightening the tension pulley mounting nut. 4. Replace fan belt if it is damaged. (1) Secondary (safety) element (2) Primary element (3) Evacuator valve (4) Cover IMPORTANT :

The air cleaner uses a dry element; never apply oil. Do not run the engine with the filter element removed. Be sure to refit the cover with the arrow (1) Adjusting bolt (2) Alternator mounting bolt (A) Check the belt tension (B) To tighten 4. Adjusting brake pedal (on the rear of the cover) upright. If the cover is improperly fitted, the evacuator valve will not function and dust will adhere to the element. Do not touch the secondary element except in cases where replacing is required. (See Replacing air cleaner primary element and secondary element on page 127.) WARNING To avoid personal injury or death:

Park on flat ground, stop the engine and chock the wheels before checking the brake pedal. To prevent uneven braking, the specification must be within the recommended limit. If found to be beyond the specification range, contact your local KUBOTA Dealer for adjusting the brakes. Evacuator valve Open the evacuator valve once a week under ordinary conditions-or daily when used in a dusty place-to get rid of large particles of dust and dirt. 4.1 Checking brake pedal free travel 3. Adjusting fan belt tension WARNING To avoid personal injury or death: Be sure to stop the engine before checking the belt tension. 1. Set both parking brakes. 1. Stop the engine and remove the key.

114 M5091N, M5101N Proper brake pedal free travel 7 to 14 mm on the pedal Keep the free travel in the right and left brake pedals equal. Proper fan belt ten- sion A deflection of between 10 to 12 mm when the belt is pressed in the middle of the span.