STARTING THE TRACTOR OPERATING THE TRACTOR 5.1 With trailer connector Appropriate care should be taken during hard braking and/or when pulling towed loads. Do not brake suddenly. An accident may occur as a result of a heavy towed load shifting forward or loss of control. To avoid skidding and loss of steering control when driving on icy, wet, or loose surfaces, make sure the tractor is correctly ballasted, operated at reduced speed and operated with the front-wheel drive engaged (if equipped). The braking characteristics are different between 2 and 4-wheel drive. Be aware of the difference and use carefully.
When driving down a slope, ensure that the 4- wheel drive is engaged to increase traction and braking efficacy (if equipped). When you operate the turn signal light switch with the trailer power connector connected, the trailer indicator in the instrumental panel also starts flashing along with the turn signal indicator. 1. Before operating the tractor on the road, be sure to interlock the right and left pedals as in the following illustration. 2. Use individual brakes to assist in making sharp turns at low speeds (field operation only). Disengage the brake pedal lock and depress only one brake pedal. 3. Be sure brake pedals have equal adjustment when being used locked together.
(1) Hazard and turn signal indicator (2) Trailer indicator 6. Horn button The horn will sound when the key switch is in position and horn button is pushed. (1) Horn button (A) 7. Brake pedals (right and left) (1) Brake pedal lock (A) (B) “RELEASE” 7.1 4WD braking system (4WD model) WARNING To avoid personal injury or death: Be sure to interlock the right and left pedals. Applying only one rear wheel brake at high speeds could cause the tractor to swerve or roll-over. Be sure brake pedals have equal adjustment when using locked together. Incorrect or unequal brake pedal adjustment can cause the tractor to swerve or roll-over.
Be aware of the enhanced braking characteristics of the 4-wheel braking system. The 4WD model tractor is equipped with 4WD braking system. When both brake pedals are applied together, the front axle is engaged for 4-wheel braking regardless of the mode selected at the 4WD switch. WARNING To avoid the possibility of personal injury, death or property damage from machine runaway during testing, service or repair with the rear wheels off the ground, make sure: Battery is disconnected and engine is not started. M5091N, M5101N 47