Kubota — 2. Remote control valve lever

HYDRAULIC UNIT REMOTE HYDRAULIC CONTROL SYSTEM 2. Remote control valve lever The remote control valve lever directs pressurized oil flow to the implement hydraulic system. Example: Installing 5 segment valves (1) Remote control valve lever 1 (2) Remote control valve lever 2 (3) Remote control valve lever 3 (4) Remote control valve lever 4 (5) Remote control valve lever 5 IMPORTANT : Do not hold the lever in the or position once the remote cylinder has reached the end of the stroke, as this will cause oil to flow through the relief valve. Forcing oil through the relief valve for extended periods will overheat the oil. NOTE :

Connect the pressure of load side of implement cylinders to ports (B), (D), (F), (H) or (J) which have built-in load check valves to prevent leakage. To use the single-acting cylinder with the float valve, connect this cylinder to the (B), (D), (F), (H) or (J) port. To extend a single-acting cylinder, pull the remote control valve lever rearward. To retract a cylinder, push it fully forward to the “FLOAT” position. Do not hold it in the down position or the transmission fluid may overheat.

Pressure Returning 80 M5091N, M5101N Lever 2 Lever position Z (detent) Y X Z (detent) Port (C) out in (D) in out 1st Double acting valve with detents and self canceling (standard) 2nd Double acting valve with detents and self canceling (standard) 3rd Double acting valve with float position (option) 4th Double acting valve with float position (option) 5th Single or double acting valve (option) Lever 3 Lever position Z (detent) Y X Port (E) in Float out in (F) out in out Lever 4 Lever position Z (detent) Y X Port (G) in Float out in (H) out in out Lever 5 Double-acting Single-acting Lever position Y X Y X Port (I) out in - - (J) in out in out Lever 1 Lever position Z (detent) Y X Z (detent) Port (A) out in (B) in out