Kubota — 4. Controlling and adjusting the flow rate

REMOTE HYDRAULIC CONTROL SYSTEM HYDRAULIC UNIT 3. Remote control valve coupler 3. To maintain within limits, the constant speed of an attachment (hydraulic motor RPM, for example) when connected to the remote control valves (1) and/or (2). WARNING To avoid personal injury or death: Stop the engine and relieve pressure before connecting or disconnecting lines. Do not use your hands to check for leaks. NOTE : At slower engine speeds the total hydraulic flow rate may be inadequate for simultaneous operation of the remote control valves (1) and/or (2) and the 3-point hitch, or operation of an attachment connected to the remote control valves (1) (2).

Under these conditions, the engine speed must be increased to provide additional hydraulic flow. Connecting 1. Clean both couplers. 2. Remove dust plugs. 3. Insert the implement coupler into the tractor hydraulic coupler. 4. Pull the implement coupler slightly to make sure couplers are firmly connected. Disconnecting 1. Lower the implement to the ground to release hydraulic pressure from the hoses. 2. Clean the couplers. 3. Relieve pressure by moving hydraulic control levers with engine shut off. Pull the hose straight from the hydraulic coupler to release it. 4. Clean oil and dust from the coupler, then replace the dust plugs. NOTE :

Your local KUBOTA Dealer can supply parts for adapting couplers to hydraulic hoses. 4. Controlling and adjusting the flow rate WARNING To avoid the possibility of personal injury or death be aware of the following when making adjustments: The 3-point hitch operation is influenced by the combination of the adjustment of the flow control valve and the engine speed. The 3-point hitch may rise slowly or not at all at low engine rpm. The 3-point hitch may rise suddenly if engine rpm is increased, or, flow control adjustment is changed.

(1) Remote control valve (1) with flow control (2) Remote control valve (2) with flow control (3) Flow control knob for valve (1) (4) Flow control knob for valve (2) Adjusting the flow rate 1. The flow rate for the remote control valves (1) and (2) can be adjusted. 2. Turn the flow control knobs (3) and/or (4) counterclockwise (A), and the flow rate for the remote control valves (1) and/or (2) increases. A clockwise turn (B) of the knob causes the flow to decrease. If the knob is turned all the way (C), there will be no flow. 3.

To adjust the flow rate, set the engine speed to the operating RPM, turn the flow control knob once all Flow control The remote control valve with flow control may be added for the following purposes. 1. The attachments that are connected with the auxiliary control valve can be independently adjusted for flow rate. 2. To operate within limits, the remote control valves (1) and/or (2) and the 3-point hitch at the same time without one affecting the other. M5091N, M5101N 81