44 Operation Section Engine Starting i01646248 After Starting Engine Note: In temperatures from 0 to 60 C (32 to 140 F), the warm-up time is approximately three minutes. In temperatures below 0 C (32 F), additional warm-up time may be required. SMCS Code: 1000 Note: Ensure that the self test for the monitoring system (if equipped) is completed before operating the engine under load. When the engine idles during warm-up, observe the following conditions: Check for any fluid or for any air leaks at idle rpm and at one-half full rpm (no load on the engine) before operating the engine under load. This is not possible in some applications.
Operate the engine at low idle until all systems achieve operating temperatures. Check all gauges during the warm-up period. Note: Gauge readings should be observed and the data should be recorded frequently while the engine is operating. Comparing the data over time will help to determine normal readings for each gauge. Comparing data over time will also help detect abnormal operating developments. Significant changes in the readings should be investigated.