45 Operation Section Engine Operation Engine Operation i01646335 Engaging the Driven Equipment i00718869 Engine Operation SMCS Code: 1000 SMCS Code: 1000 Proper operation and maintenance are key factors in obtaining the maximum life and economy of the engine. If the directions in the Operation and Maintenance Manual are followed, costs can be minimized and engine service life can be maximized. 1. Operate the engine at one-half of the rated rpm, when possible. 2. Engage the driven equipment without a load on the equipment, when possible. Interrupted starts put excessive stress on the drive train. Interrupted starts also waste fuel.
To get the driven equipment in motion, engage the clutch smoothly with no load on the equipment. This method should produce a start that is smooth and easy. The engine rpm should not increase and the clutch should not slip. The time that is needed for the engine to reach normal operating temperature can be less than the time needed for a walk-around inspection of the engine. After the engine is started and after the engine reaches normal operating temperature, the engine can be operated at the rated rpm. The engine will reach normal operating temperature faster when the engine is at rated speed. The engine will reach normal operating temperature faster when the engine is at low power demand.
This procedure is more effective than idling the engine at no load. The engine should reach operating temperature in a few minutes. 3. Ensure that the ranges of the gauges are normal when the engine is operating at one-half of the rated rpm. Ensure that all gauges operate properly. 4. Increase the engine rpm to the rated rpm. Always increase the engine rpm to the rated rpm before the load is applied. 5. Apply the load. Begin operating the engine at low load. Check the gauges and equipment for proper operation. After normal oil pressure is reached and the temperature gauge begins to move, the engine may be operated at full load.
Check the gauges and equipment frequently when the engine is operated under load. Gauge readings should be observed and the data should be recorded frequently while the engine is operating. Comparing the data over time will help to determine normal readings for each gauge. Comparing data over time will also help detect abnormal operating developments. Significant changes in the readings should be investigated. Extended operation at low idle or at reduced load may cause increased oil consumption and carbon buildup in the cylinders. This carbon buildup results in a loss of power and/or poor performance.