76 Maintenance Section Air Tank Moisture and Sediment - Drain i00847451 Air Tank Moisture and Sediment - Drain (If Equipped) Check the alternator and the battery charger for proper operation. If the batteries are properly charged, the ammeter reading should be very near zero. All batteries should be kept charged. The batteries should be kept warm because temperature affects the cranking power. If the battery is too cold, the battery will not crank the engine. The battery will not crank the engine, even if the engine is warm. When the engine is not run for long periods of time or if the engine is run for short periods, the batteries may not fully charge.
A battery with a low charge will freeze more easily than a battery with a full charge. SMCS Code: 1466-543-M&S Moisture and sediment in the air starting system can cause the following conditions: Freezing Corrosion of internal parts i01492550 Battery - Replace Malfunction of the air starting system SMCS Code: 1401-510 When opening the drain valve, wear protective gloves, a protective face shield, protective cloth- ing, and protective shoes. Pressurized air could cause debris to be blown and result in personal injury. Batteries give off combustible gases which can explode. A spark can cause the combustible gas- es to ignite. This can result in severe personal in- jury or death. 1.
Open the drain valve that is on the bottom of the air tank. Allow the moisture and sediment to drain. Ensure proper ventilation for batteries that are in an enclosure. Follow the proper procedures in or- der to help prevent electrical arcs and/or sparks near batteries. Do not smoke when batteries are serviced. 2. Close the drain valve. 3. Check the air supply pressure. The air starting motor requires a minimum of 620 kPa (90 psi) of air pressure to operate properly. The maximum air pressure must not exceed 1550 kPa (225 psi). The normal air pressure will be 758 to 965 kPa (110 to 140 psi). The battery cables or the batteries should not be removed with the battery cover in place.
The bat- tery cover should be removed before any servic- ing is attempted. i00072207 Alternator - Inspect Removing the battery cables or the batteries with the cover in place may cause a battery explosion resulting in personal injury. SMCS Code: 1405-040 1. Turn the key start switch to the OFF position. Remove the key and all electrical loads. Caterpillar recommends a scheduled inspection of the alternator. Inspect the alternator for loose connections and proper battery charging. Inspect the ammeter (if equipped) during engine operation in order to ensure proper battery performance and/or proper performance of the electrical system. Make repairs, as required. Refer to the Service Manual. 2.
Turn OFF the battery charger. Disconnect the charger. 3. The NEGATIVE cable connects the NEGATIVE battery terminal to the ground plane. Disconnect the cable from the NEGATIVE battery terminal. 4. The POSITIVE cable connects the POSITIVE battery terminal to the starting motor. Disconnect the cable from the POSITIVE battery terminal.