85 Maintenance Section Cooling System Supplemental Coolant Additive (SCA) - Test/Add Level 1 i01463635 Cooling System Supplemental Coolant Additive (SCA) - Test/Add Level 1 is a basic analysis of the coolant. The following items are tested: Glycol Concentration SMCS Code: 1352-045; 1395-081 Concentration of SCA pH Cooling system coolant additive contains alkali. To help prevent personal injury, avoid contact with the skin and the eyes. Do not drink cooling system coolant additive. Conductivity The results are reported, and recommendations are made according to the results.
Consult your Caterpillar dealer for information on the benefits of managing your equipment with an S·O·S Coolant Analysis. Note: Test the concentration of the Supplemental Coolant Additive (SCA) or test the SCA concentration as part of an S·O·S Coolant Analysis. Level 2 Test for SCA Concentration This level coolant analysis is recommended when the engine is overhauled. Refer to the Operations and Maintenance Manual, “Overhaul Considerations” for further information. Coolant/Antifreeze and SCA NOTICE Do not exceed the recommended six percent supple- mental coolant additive concentration.
Add the SCA, If Necessary Use the 8T-5296 Coolant Conditioner Test Kit or use the 4C-9301 Coolant Conditioner Test Kit in order to check the concentration of the SCA. Refer to the Operation and Maintenance Manual for more information. NOTICE Do not exceed the recommended amount of sup- plemental coolant additive concentration. Excessive supplemental coolant additive concentration can form deposits on the higher temperature surfaces of the cooling system, reducing the engine’s heat transfer characteristics. Reduced heat transfer could cause cracking of the cylinder head and other high temper- ature components.
Excessive supplemental coolant additive concentration could also result in radiator tube blockage, overheating, and/or accelerated water pump seal wear. Never use both liquid supplemental coolant additive and the spin-on element (if equipped) at the same time. The use of those additives together could result in supplemental coolant additive concen- tration exceeding the recommended maximum. Water and SCA NOTICE Do not exceed the recommended eight percent sup- plemental coolant additive concentration. Test the concentration of the SCA with the 8T-5296 Coolant Conditioner Test Kit.
Refer to the Operation and Maintenance Manual, “Water/Supplemental Coolant Additive (SCA)” topic (Maintenance Section). Refer to the Operation and Maintenance Manual, “Conventional Coolant/Antifreeze Cooling System Maintenance” topic (Maintenance Section). Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pres- sure. S·O·S Coolant Analysis S·O·S coolant samples can be analyzed at your Caterpillar dealer. S·O·S Coolant Analysis is a program that is based on periodic samples. 1.
Slowly loosen the cooling system filler cap in order to relieve the pressure. Remove the cooling system filler cap.