Caterpillar — Maintenance Interval Schedule

86 Maintenance Section Cooling System Water Temperature Regulator - Replace Note: Always discard drained fluids according to local regulations. NOTICE Failure to replace your water temperature regulator on a regularly scheduled basis could cause severe engine damage. 2. If necessary, drain some coolant from the cooling system into a suitable container in order to allow space for the extra SCA. 3. Add the proper amount of SCA. Refer to the Operation and Maintenance Manual for more information on SCA requirements. Caterpillar engines incorporate a shunt design cooling system and require operating the engine with a water temperature regulator installed.

If the water temperature regulator is installed incor- rectly, the engine may overheat, causing cylinder head damage. Ensure that the new water temperature reg- ulator is installed in the original position. Ensure that the water temperature regulator vent hole is open. 4. Clean the cooling system filler cap. Inspect the gaskets of the cooling system filler cap. If the gaskets are damaged, replace the old cooling system filler cap with a new cooling system filler cap. Install the cooling system filler cap. Do not use liquid gasket material on the gasket or cylinder head surface.

i00912898 Cooling System Water Temperature Regulator - Replace Refer to the Service Manual for the replacement procedure of the water temperature regulator, or consult your Caterpillar dealer. SMCS Code: 1355-510 Note: If only the water temperature regulators are replaced, drain the coolant from the cooling system to a level that is below the water temperature regulator housing. Replace the water temperature regulator before the water temperature regulator fails. This is a recommended preventive maintenance practice. Replacing the water temperature regulator reduces the chances for unscheduled downtime.

i00072369 Crankshaft Vibration Damper - Inspect A water temperature regulator that fails in a partially opened position can cause overheating or overcooling of the engine. SMCS Code: 1205-040 A water temperature regulator that fails in the closed position can cause excessive overheating. Excessive overheating could result in cracking of the cylinder head or piston seizure problems. Damage to the crankshaft vibration damper or failure of the crankshaft vibration damper can increase torsional vibrations. This can result in damage to the crankshaft and to other engine components. A deteriorating damper can cause excessive gear train noise at variable points in the speed range.

A water temperature regulator that fails in the open position will cause the engine operating temperature to be too low during partial load operation. Low engine operating temperatures during partial loads could cause an excessive carbon buildup inside the cylinders. This excessive carbon buildup could result in an accelerated wear of the piston rings and wear of the cylinder liner. The damper is mounted to the crankshaft which is located behind the belt guard on the front of the engine. Removal and Installation Refer to the Service Manual for the damper removal procedure and for the damper installation procedure.