Caterpillar — Maintenance Interval Schedule

95 Maintenance Section Engine Oil and Filter - Change The following plugs are used to inform the ECM when a particular grade of oil is being used. 10W30 and 15W40 oil grade plugs are shipped with the engine. The 0W20 oil grade plug can be ordered from the parts manual. Order the 214-7170 Repair Kit. The 0W20 oil grade plug can be made from a 175-3700 Connector Repair Kit. Refer to the Electrical Schematic or refer to Table 38 for the proper pin locations. Table 38 g00852969 Illustration 46 Oil grade plugs being shipped with the engine.

Drain the Engine Oil (1) Identification tag for 10W30 oil grade plug (2) Identification tag for 15W40 oil grade plug After the engine has been run at the normal operating temperature, stop the engine. Attach a NOT OPERATE” or a similar warning tag to the ignition keyswitch before the engine is serviced. Catch the oil in a suitable container. Recycle the used oil, or dispose of the used oil properly. 1. Remove the oil drain plug in order to allow the oil to drain. 2. After the oil has drained, the oil drain plug should be cleaned and installed. Replace the Oil Filter NOTICE Caterpillar oil filters are built to Caterpillar speci- fications.

Use of an oil filter not recommended by Caterpillar could result in severe engine damage to the engine bearings, crankshaft, etc., as a result of the larger waste particles from unfiltered oil entering the engine lubricating system. Only use oil filters recommended by Caterpillar. g00852892 Illustration 47 214-7170 Repair Kit (3) 10W30 oil grade plug (Green wire) (4) 15W40 oil grade plug (Red wire) (5) 0W20 oil grade plug (Black wire) 1. Remove the oil filter with a 185-3630 Strap Wrench. OIL GRADE PLUGS (214-7170) Plug Oil Grade Wire Color Pin Connections 3 10W30 Green B-C 4 15W40 Red A-C 5 0W20 Black A-B-C