96 Maintenance Section Engine Oil and Filter - Change 4. Apply clean engine oil to the new oil filter gasket. NOTICE Do not fill the oil filters with oil before installing them. This oil would not be filtered and could be contaminat- ed. Contaminated oil can cause accelerated wear to engine components. 5. Install the oil filter. Tighten the oil filter until the oil filter gasket contacts the base. Tighten the oil filter by hand according to the instructions that are shown on the oil filter. Do not overtighten the oil filter. g00588944 Illustration 48 Element with debris Fill the Engine Crankcase 2. Cut the oil filter open with a 175-7546 Oil Filter Cutter .
Break apart the pleats and inspect the oil filter for metal debris. An excessive amount of metal debris in the oil filter may indicate early wear or a pending failure. 1. Remove the oil filler cap. Refer to the Operation and Maintenance Manual, “Lubricant Specifications” topic (Maintenance Section) for more information. Fill the crankcase with the proper amount of oil. Refer to the Operation and Maintenance Manual, “Refill Capacities” topic (Maintenance Section) for more information. Use a magnet to differentiate between the ferrous metals and the nonferrous metals that are found in the oil filter element. Ferrous metals may indicate wear on the steel and cast iron parts of the engine.
NOTICE If equipped with an auxiliary oil filter or system, extra oil must be added when filling the crankcase. Follow the OEM or filter manufacturer’s recommendations. If the extra oil is not added, the engine may starve for oil. Nonferrous metals may indicate wear on the aluminum parts, brass parts or bronze parts of the engine. Parts that may be affected include the following items: main bearings, rod bearings, turbocharger bearings, and cylinder heads. NOTICE To help prevent crankshaft or bearing damage, crank engine to fill all filters before starting. Do not crank engine for more than 30 seconds.
Due to normal wear and friction, it is not uncommon to find small amounts of debris in the oil filter. Consult your Caterpillar dealer in order to arrange for a further analysis if an excessive amount of debris is found in the oil filter. 2. Start the engine and run the engine at “LOW IDLE” for two minutes. Perform this procedure in order to ensure that the lubrication system has oil and that the oil filters are filled. Inspect the oil filter for oil leaks. 3. Stop the engine and allow the oil to drain back to the sump for a minimum of ten minutes. 4. Remove the oil level gauge in order to check the oil level.
Maintain the oil level between the and marks on the “ENGINE STOPPED” side of the oil level gauge. g00103713 Illustration 49 Typical filter mounting base and filter gasket 3. Clean the sealing surface of the filter mounting base. Ensure that all of the old oil filter gasket is removed.