Section 8 Electrical System and Components Inspection Commutator O.D. Drive Pinion Check and inspect the following areas: a. The pinion teeth for abnormal wear or damage. b. The surface between the pinion and the clutch mechanism for nicks, or irregularities which could cause seal damage. c. Check the drive clutch by holding the clutch housing and rotating the pinion. The pinion should rotate in one direction only. Mica Insulation Figure 8-28. Commutator Mica Inspection. Brushes and Springs Inspect both the springs and brushes for wear, fatigue, or damage. Measure the length of each brush. The minimum length for each brush is 7.6 mm (0.300 in.) . See Figure 8-27.
Replace the brushes if they are worn undersize, or their condition is questionable. 2. Use an ohmmeter set to the Rx1 scale. Touch the probes between two different segments of the commutator, and check for continuity. See Figure 8-29. Test all the segments. Continuity must exist between all or the armature is bad. Insulation Check Continuity Check Armature Coil Wear limit length: 7.6 mm (0.300 in.) Figure 8-29. Checking Armature. Figure 8-27. Checking Brushes. 3. Check for continuity between the armature coil segments and the commutator segments. See Figure 8-29. There should be no continuity. If continuity exists between any two, the armature is bad. Armature 1.
Clean and inspect the commutator (outer surface). The mica insulation must be lower than the commutator bars (undercut) to ensure proper operation of the commutator. See Figure 8-28. 4. Check the armature windings/insulation for shorting. Shift Fork Check that the shift fork is complete, and the pivot and contact areas are not excessively worn, cracked or broken. 8.16