Section 8 Electrical System and Components Brush Replacement The brushes and springs are serviced as a set (4). Use Brush and Spring Kit, Kohler Part No. 25 221 01-S , if replacement is necessary. Starter Service Clean the drive lever and armature shaft. Apply Kohler electric starter drive lubricant (see Section 2) to the lever and shaft. Clean and check the other starter parts for wear or damage as required. 1. Perform steps 1-5 in “Starter Disassembly.” Starter Reassembly 1. Apply drive lubricant (see Section 2) to the armature shaft splines. Install the drive pinion onto the armature shaft. 2. Remove the two screws securing the brush holder assembly to the end cap (plate).
Note the orientation for reassembly later. See Figure 8-30. Discard the old brush holder assembly. 2. Install and assemble the stop collar/retainer assembly. a. Install the stop collar down onto the armature shaft with the counter bore (recess) up. b. Install a new retainer in the larger (rear) groove of the armature shaft. Squeeze with a pliers to compress it in the groove. c. Slide the stop collar up and lock it into place, so the recess surrounds the retainer in the groove. If necessary, rotate the pinion outward on the armature splines against the Figure 8-30. Removing Brush Holder. 3. Clean the component parts as required. 4.
The new brushes and springs come preassembled in a brush holder with a protective sleeve that will also serve as an installation tool. See Figure 8-31. Figure 8-32. Installing Stop Collar and Retainer. NOTE: Always use a new retainer. Do not reuse old retainers which have been removed. Figure 8-31. Service Brush Kit. 3. Install the offset thrust (stop) washer so the smaller “offset” of the washer faces the retainer/ collar. See Figure 8-33. 5. Perform Steps 10-13 in the “Starter Reassembly” sequence. Installation must be done after the armature, drive lever, and frame are installed, if the starter has been disassembled. 8.17 8