Section 8 Electrical System and Components 7. Install the backup washer, followed by the rubber grommet, into the matching recess of the drive end cap. The molded recesses in the grommet should be “out”, matching and aligned with those in the end cap. See Figure 8-35. Figure 8-33. Installing Thrust Washer. 4. Apply a small amount of oil to the bearing in the drive end cap, and install the armature with the drive pinion. 5. Lubricate the fork end and center pivot of the drive lever with drive lubricant (see Section 2). Position the fork end into the space between the captured washer and the rear of the pinion. Figure 8-35. Installing Backup Washer and Grommet. 8.
Install the frame, with the small notch forward, onto the armature and drive end cap. Align the notch with the corresponding section in the rubber grommet. Install the drain tube in the rear cutout, if it was removed previously. See Figure 8-36. 6. Slide the armature into the drive end cap, and at the same time seat the drive lever into the housing. NOTE: Correctly installed, the center pivot section of the drive lever will be flush or below the machined surface of the housing which receives the backup washer. See Figure 8-34. Figure 8-36. Installing Frame and Drain Tube. 9. Install the flat thrust washer onto the commutator end of the armature shaft. See Figure 8-37. Figure 8-34.
Installing Armature and Pivot Lever. 8.18