Section 8 Electrical System and Components Figure 8-37. Installing Thrust Washer. Figure 8-39. Removing Retaining Clips. 10. Starter reassembly when replacing the Brushes/ Brush Holder Assembly: b. Position each of the brushes back in their slots so they are flush with the I.D. of the brush holder assembly. Insert the Brush Installation Tool (with extension), or use the tube described above from a prior brush installation, through the brush holder assembly, so the holes in the metal mounting clips are “up/out.” a.
Hold the starter assembly vertically on the end housing, and carefully position the assembled brush holder assembly, with the supplied protective tube, against the end of the commutator/armature. The mounting screw holes in the metal clips must be “up/ out.” Slide the brush holder assembly down into place around the commutator, and install the positive (+) brush lead grommet in the cutout of the frame. See Figure 8-38. The protective tube may be saved and used for future servicing. c. Install the brush springs and snap on the four retainer caps. See Figure 8-40. 8 Figure 8-40. Brush Installation Tool with Extension. d.
Hold the starter assembly vertically on the end housing, and carefully place the tool (with extension) and assembled original brush holder assembly onto the end of the armature shaft. Slide the brush holder assembly down into place around the commutator, install the positive (+) brush lead grommet in the cutout of the frame. See Figure 8-41. Figure 8-38. Installing Brush Holder Assembly with Supplied Tube. Starter reassembly when not replacing the Brushes/ Brush Holder Assembly: a. Carefully unhook the retaining caps from over each of the brush assemblies. Do not lose the springs. 8.19