Aegis LH630-775 — Section 9 - Disassembly

Section 9 Disassembly Section 9 Disassembly Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable from battery. WARNING: Accidental Starts! General Clean all parts thoroughly as the engine is disassembled. Only clean parts can be accurately inspected and gauged for wear or damage. There are many commercially available cleaners that will quickly remove grease, oil, and grime from engine parts. When such a cleaner is used, follow the manufacturer’s instructions and safety precautions carefully. 18. Remove flywheel. 19.

Remove stator assembly. 20. Remove intake manifold, thermostat housing, by-pass hose and wiring harness. 21. Remove cam pulley and water pump belt. 22. Remove water pump and transfer tube. 23. Remove spark plugs. 24. Remove cylinder heads and valve lifters. 25. Remove closure plate. 26. Remove camshaft. 27. Remove connecting rods with pistons and rings. 28. Remove crankshaft. 29. Remove governor cross shaft. 30. Remove flywheel end oil seals. Make sure all traces of the cleaner are removed before the engine is reassembled and placed into operation. Even small amounts of these cleaners can quickly break down the lubricating properties of engine oil.

Typical Disassembly Sequence The following sequence is suggested for complete engine disassembly. The sequence can be varied to accommodate options or special equipment. Disconnect Spark Plug Leads 1. Disconnect the leads from the spark plugs. See Figure 9-1. 9 NOTE: Pull on boot only, to prevent damage to spark plug lead. 1. Disconnect spark plug leads. 2. Shut off fuel supply. 3. Remove muffler. 4. Remove starter and adapter plate. 5. Drain coolant from cooling system. 6. Drain oil from crankcase and remove oil filter. 7. Remove flywheel cover, radiator assembly, mounting brackets, and attached components. 8. Remove air cleaner assembly. 9. Remove throttle and choke controls. 10.

Remove external governor controls. 11. Remove carburetor and adapter. 12. Remove Oil Sentry™. 13. Remove breather cover. 14. Remove valve covers. 15. Remove lower drive pulley and fan belt. 16. Remove fan assembly, mounting bracket and fan shaft. 17. Remove ignition modules. Figure 9-1. Disconnecting Spark Plug Leads. 9.1