Section 9 Disassembly Shut Off Fuel Supply Drain Coolant from Cooling System 1. Loosen the radiator cap, then loosen the radiator drain plug and allow the system to drain. Use a suitable container to catch the coolant. See Figure 9-4. Remove Muffler 1. Remove the exhaust system, muffler, and attaching hardware from the engine. Remove Starter and Adapter Plate 1. Disconnect the leads attached to the starter solenoid terminals. 2. Remove the two hex flange screws securing the starter to the adapter plate. See Figure 9-2. Radiator Drain Plug Drain Plug Figure 9-2. Removing Starter Assembly. 3. Remove the two hex flange screws attaching the adapter to the crankcase.
Note the orientation of the cutout. The upper screw may also secure a clamp for the stator leads. Figure 9-4. Radiator Drain Plug. 2. If equipped, remove the coolant drain plugs on each side of block. Allow any remaining coolant to drain out. See Figure 9-5. Dispose of the coolant properly, according to local regulations. Figure 9-3. Removing the Adapter Plate Screws. Figure 9-5. Removing Coolant Drain Plugs in Block. 9.2