Section 9 Disassembly Drain Oil from Crankcase and Remove Oil Filter 1. Remove the oil fill cap and dipstick, and one or both of the drain plugs. See Figures 9-6 and 9-7. Allow sufficient time for the oil to drain out. Remove Flywheel Cover, Radiator Assembly, Mounting Brackets and Attached Components 1. Remove the screws or nuts and flat washers (2 on each side) securing the lower flywheel cover to the LH and RH radiator support brackets. See Figure 9-8. The mounting plate for the rectifier- regulator will become detached when the LH screws are removed. Do not lose the small spacers located within the holes of the lower cover. Clips are used on some models instead of hex nuts.
Oil Fill Cap Dipstick Figure 9-6. Removing Oil Fill Cap and Dipstick. Figure 9-8. Removing Lower Flywheel Cover. 2. If a "pulse" style fuel pump is used, disconnect the fuel line from the pump outlet, and disconnect the pulse line from the fuel pump fitting. See Figure 9-9. Oil Drain Plug 9 Oil Filter Pump Outlet Figure 9-7. Oil Drain Plugs and Oil Filter. Pulse Line Oil Drain Plug 2. Remove and discard the oil filter. Figure 9-9. Fuel Line and Pump Pulse Line. 3. Disconnect the upper radiator hose from the radiator, and the lower radiator hose from the inlet of the water pump. See Figure 9-10. 9.3