Aegis LH630-775 — Section 9 - Disassembly

Section 9 Disassembly 8. Further disassembly for component servicing may be performed as required. 3. Lift the air cleaner/mounting bracket assembly off the engine. See Figure 9-17. Remove Air Cleaner Assembly 1. Remove the two screws securing the elbow adapter and gasket to the carburetor. See Figure 9-15. Figure 9-17. Removing Air Cleaner From Engine. Remove Throttle and Choke Controls 1. Remove the four hex flange screws securing the main control bracket to the cylinder heads. See Figure 9-18. Figure 9-15. Removing Elbow Adapter Mounting Screws. 2. Remove the two upper valve cover mounting screws on each side, which also secure the main mounting bracket for the air cleaner.

See Figure 9-16. Figure 9-18. Removing the Four Screws From Main Control Bracket. 2. Mark the hole location and disconnect the governor spring from the governor lever. Figure 9-16. Removing Upper Valve Cover Mounting Bracket Screws. 9.5 9