Section 9 Disassembly 3. Tilt the main bracket and disconnect the choke linkage from the choke lever. See Figure 9-19. Remove the main control bracket. Figure 9-21. Loosening Governor Lever Mounting Nut. Figure 9-19. Tilting Bracket and Unhooking Choke Link. Remove Carburetor and Adapter WARNING: Explosive Fuel! Gasoline is extremely flammable and its vapors can explode if ignited. Store gasoline only in approved containers, in well ventilated, unoccupied buildings, away from sparks or flames. Do not fill the fuel tank while the engine is hot or running, since spilled fuel could ignite if it comes in contact with hot parts or sparks from ignition. Do not start the engine near spilled fuel.
Never use gasoline as a cleaning agent. 4. Unhook the choke linkage from the actuator lever on carburetor. See Figure 9-20. 1. Disconnect the lead to the fuel shut-off solenoid (if equipped). If a mechanical fuel pump is used, disconnect the fuel line from the carburetor inlet. 2. Disconnect the breather hose from the adapter fitting on the carburetor. 3. Remove the two carburetor mounting screws. See Figure 9-22. If a flexible tube and knob idle speed adjuster is used, open the retaining clamp and unhook. Figure 9-20. Disconnecting Choke Linkage from Carburetor. Remove External Governor Controls 1. Loosen the hex flange nut of the governor lever mounting screw. See Figure 9-21.
Leave the throttle linkage and spring connected to the lever. Lift the governor lever off of the governor shaft and lay the assembly on top of the crankcase, to be removed with the carburetor. Figure 9-22. Removing the Carburetor Mounting Screws. 9.6