Aegis LH630-775 — Section 9 - Disassembly

Section 9 Disassembly 4. Remove the carburetor, throttle linkage and governor lever as an assembly. See Figure 9-23. Figure 9-25. Removing the Breather Cover Screws. Figure 9-23. Removing Carburetor from Engine. 2. Carefully pry under the protruding edge of the breather cover to separate and remove the cover from the gasket. See Figure 9-26. 5. Remove the carburetor gasket. 6. The carburetor, adapter, throttle linkage, and governor lever may be separated for individual component servicing as required. If the linkages are separated, reattach the bushings to the linkages to prevent them from being lost. Remove Oil Sentry™ (If So Equipped) 1.

Disconnect the wire lead from the Oil Sentry™ switch, and remove the switch from the breather cover. See Figure 9-24. Do not pry on the sealing surfaces as it could cause damage resulting in leaks. 3. Remove the breather gasket and fiber filter from the breather chamber. See Figure 9-27. Figure 9-24. Oil Sentry™ Location on Engine. Remove Breather Cover 1. Remove the four hex flange screws securing the breather cover to the crankcase. See Figure 9-25. Figure 9-27. Removing the Breather Gasket and Filter. 9.7 9 Figure 9-26. Prying Off the Breather Cover.