Section 9 Disassembly 2. Remove the pulley halves with the spacer shims from the adapter, and take the fan belt off the upper pulley/fan assembly. Note the number of shims between pulley halves, and on the front side of pulley, especially if the same belt will be reinstalled. See Figure 9-32. NOTE: Further disassembly of the fan/hub and pulley assembly is not necessary unless a problem exists; see "Inspection - Cooling Fan Assembly, Belt, and Drive Pulleys" (Section 7). If disassembly is performed, note the assembly order and position of parts. See Figure 9-34. Figure 9-32. Disassembled Lower Pulley Assembly. Figure 9-34. Disassembled Fan Assembly Component.
Remove Fan Assembly, Mounting Bracket, and Fan Shaft 1. Remove the front hex flange nut and washer securing the fan assembly to the fan shaft. Remove the fan and pulley assembly from the upper mounting bracket. See Figure 9-33. 2. Remove the two hex flange screws and take off the mounting bracket, with the fan shaft attached. See Figure 9-35. Figure 9-35. Removing Upper Fan Mounting Bracket Screws. Figure 9-33. Removing Front Flange Nut and Flat Washer. 3. The fan shaft may be removed from the mounting bracket, by removing the rear hex flange nut, if individual servicing of either part is required. 9.9 9