Section 9 Disassembly Remove Ignition Modules 1. Disconnect the kill leads from the ignition modules. See Figure 9-36. Figure 9-38. Removing Flywheel Screw and Washer. 2. Use a puller to remove the flywheel from the crankshaft. See Figure 9-39. Figure 9-36. Removing Kill Leads from Ignition Modules. 2. Rotate the flywheel, so the magnet is away from the ignition modules. 3. Remove the mounting screws and take off each ignition module. See Figure 9-37. Figure 9-39. Removing Flywheel with Puller. NOTE: Always use a flywheel puller to remove the flywheel from the crankshaft. Do not strike the crankshaft or flywheel, as these parts could become cracked or damaged. Figure 9-37.
Removing Ignition Modules. Remove Flywheel 1. Use a flywheel strap wrench or holding tool (see Section 2) to hold the flywheel. Remove the hex flange screw and flat washer. See Figure 9-38. 3. Remove the woodruff key from the crankshaft keyway. 9.10