Aegis LH630-775 — Section 9 - Disassembly

Section 9 Disassembly Remove Stator Assembly 1. Remove the two mounting screws, and pull the stator, with the plug-in connector attached, from the engine. See Figure 9-40. 2. Remove the six mounting screws and carefully separate the intake manifold from the cylinder heads, with the by-pass hose and wiring harness attached. See Figures 9-42 and 9-43. Figure 9-40. Removing Stator Screws. Figure 9-42. Removing the Six Intake Manifold Screws. Remove Intake Manifold, Thermostat Housing, By-pass Hose and Wiring Harness 1. Disconnect the by-pass hose from the fitting on the water pump. See Figure 9-41. Figure 9-43. Removing the Intake Manifold Assembly from the Engine. 3.

Remove the intake manifold gaskets. Figure 9-41. Removing By-pass Hose from Water Pump Fitting. 9.11 9