Section 9 Disassembly 4. Further disassembly of the intake manifold components may be performed as necessary. If the thermostat is to be removed, loosen and remove the two hex flange screws securing the thermostat housing to the intake manifold. Separate the housing and remove the thermostat, discard the old gasket. Disassembled components are shown in Figure 9-44. Figure 9-46. Removing Cam Pulley and Belt. 3. Remove the camshaft key from the keyway. Remove Water Pump and Transfer Tube 1. Loosen and unscrew the hex cap section securing the transfer tube to the 90° fitting in the crankcase. See Figure 9-47. Support the fitting with a wrench, when loosening the hex cap section. Figure 9-44.
Disassembled Intake Manifold Assembly Components. Remove Camshaft Pulley and Water Pump Belt 1. Remove the hex flange screw and flat washer, securing the cogged drive pulley to the camshaft. See Figure 9-45. Figure 9-47. Loosening Hex Cap Section of Fitting. 2. Remove the six screws securing the water pump to the crankcase. See Figure 9-48. Figure 9-45. Removing Cam Pulley Hardware. 2. Carefully lift the pulley off the camshaft and remove the belt from the water pump pulley. See Figure 9-46. 9.12