Section 9 Disassembly Remove Spark Plugs 1. Remove the spark plugs from the cylinder heads using a spark plug socket. See Figure 9-50. Figure 9-48. Removing Water Pump Screws. 3. Lift the water pump up, and carefully work the ferruled end of the transfer tube out of the fitting. Remove the water pump with the transfer tube and the hose section attached. Remove and discard the O-Ring from within the channel of the pump housing. See Figure 9-49. Figure 9-50. Removing Spark Plugs. Remove Cylinder Heads and Valve Lifters 1. Rotate the crankshaft of the engine until the valves of one cylinder are closed. Loosen the rocker arm screws until the rocker arms can be pivoted to free the push rods.
See Figure 9-51. Figure 9-49. Removing the Water Pump Assembly from Block. Figure 9-51. Loosening the Rocker Arm Screws. 4. Inspect and, if necessary, separate the transfer tube and hose section from the water pump. Remove the hose clamps, noting their size differences and position of tangs. 2. Remove the push rods and mark their location as either intake or exhaust, and cylinder 1 or 2. The push rods should always be reinstalled in their original position. IMPORTANT: The 90° fitting in the crankcase, which the transfer tube is connected to, is sealed and installed at the factory in a specific position. Do not loosen, remove, or alter the mounted position of this fitting at any time.
Contact the factory service department for specific instructions if the fitting is damaged, or its mounting is affected in any way. 3. Repeat for the opposite cylinder. 9.13 9