Aegis LH630-775 — Section 9 - Disassembly

Section 9 Disassembly 4. Remove the four hex flange nuts and washers from the cylinder head studs. Carefully remove the cylinder heads and head gaskets. See Figure 9-52. Disassemble Cylinder Heads 1. Remove the two hex flange screws, rocker arms and pivots from the cylinder head(s). See Figure 9-54. Figure 9-52. Removing Cylinder Heads and Gaskets. Figure 9-54. Removed Rocker Arms and Pivots. 2. Compress the valve springs using a valve spring compressor and remove the valve spring keepers. Remove the compressor. See Figure 9-55. 5. Remove the hydraulic lifters using a hydraulic lifter removing tool ( do not use a magnet ).

Mark them similar to the push rods (intake or exhaust and cylinder 1 or 2). Hydraulic lifters should always be reinstalled in their original location. See Figure 9-53. Figure 9-55. Compressing Valve Springs. Figure 9-53. Removing Lifters. 3. With the keepers taken out the following items can be removed. See Figure 9-56. NOTE: It is not necessary to remove the cylinder studs from the crankcase unless replacement is intended. If studs are removed for any reason, discard the old stud(s), do not reuse/reinstall. Use new studs and refer to the assembly sequence for proper installation.

• valve spring retainers • valve springs • valve spring caps • intake and exhaust valves • valve stem seals (intake valve only) 9.14