Section 9 Disassembly Remove Closure Plate 1. Remove the ten hex flange screws securing the closure plate to the crankcase. See Figure 9-58. If a thick washer is installed under the screw head in the #10 location, and/or one silver (ground) screw is used, (normally the No. 4 or 6 position), note these special assembly details for proper reassembly later. Figure 9-56. Disassembled Head and Valve Components. NOTE: These engines use a valve stem seal on the intake and exhaust valves. Serial No. 3422000010 and lower used a seal on intake side only. See Figure 9-57. Always use new seals when the valves are removed from the cylinder head.
Replace the seals if they are deteriorated or damaged in any way. Never reuse an old seal. Figure 9-58. Removing Closure Plate Screws. 2. Locate the three splitting tabs, which are cast into the perimeter of the closure plate. Insert the drive end of a 1/2" breaker bar between the top splitting tab and the crankcase. Hold the handle horizontal and pull it toward you to break the RTV seal. See Figure 9-59. If necessary, pry at the bottom splitting tabs also. Do not pry on the sealing surfaces, as this could cause leaks. Carefully pull the closure plate from the crankcase. 9 Figure 9-57. Cylinder Head Showing Intake Seal. 4. Repeat the above procedure for the other cylinder head.
Do not interchange parts from one cylinder head with parts from the other cylinder head. Figure 9-59. Splitting Closure Plate from Crankcase. 9.15