Section 9 Disassembly Governor Assembly The governor assembly is located inside the closure plate. If service is required, refer to the service procedures under "Governor Assembly" in Section 10. NOTE: The cylinders are numbered on the crankcase. Use the numbers to mark each end cap and connecting rod/piston assembly for reassembly later. Do not mix the end caps and connecting rods. Oil Pump Assembly The oil pump is mounted to the inside of the closure plate as well. If service is required, refer to the service procedures under "Oil Pump Assembly" in Section 10. 2. Carefully remove the connecting rod and piston assembly from the cylinder bore. See Figure 9-62. Remove Camshaft 1.
Remove the camshaft and shims. See Figure 9-60. Figure 9-62. Removing Piston(s). 3. Repeat the above procedure for the other connecting rod and piston assembly. Figure 9-60. Removing Camshaft with Shim. Remove Crankshaft 1. Carefully pull the crankshaft from the crankcase. See Figure 9-63. Note the thrust washer and shims if used. Remove Connecting Rods with Pistons and Rings 1. Remove the two hex flange screws securing the closest connecting rod end cap. Remove the end cap. See Figure 9-61. Figure 9-63. Removing Crankshaft. Figure 9-61. Removing Connecting Rod End Cap. NOTE:
If a carbon ridge is present at the top of either cylinder bore, use a ridge reamer tool to remove it before attempting to remove the piston. 9.16