Section 9 Disassembly Remove Governor Cross Shaft 1. Remove the retaining ring and nylon washer from the governor cross shaft. See Figure 9-64. Remove Flywheel End Oil Seals 1. Remove the flywheel end crankshaft and camshaft oil seals from the crankcase. See Figure 9-66. Figure 9-64. Removing Governor Shaft Retaining Ring and Washer. Figure 9-66. Oil Seals (Flywheel Side and Camshaft). NOTE: Always use a new retaining ring when reassembling. Do not reuse the old retaining ring. 2. Remove the cross shaft and small washer out through the inside of the crankcase. See Figure 9-65. 9 Figure 9-65. Removing Governor Cross Shaft. 9.17