Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly 4. Install the breather filter into the cavity in the crankcase. See Figure 11-24. 1 3 2 4 Figure 11-26. Breather Cover Fastener Torque Sequence. Figure 11-24. Installing Breather Filter. 7. Install the pipe plug or Oil Sentry™ switch (as equipped), into the tapped breather port if removed earlier. Apply pipe sealant with Teflon ® 5. Carefully install the breather cover gasket and breather cover onto the crankcase. See Figure 11-25. (Loctite ® 59241 or equivalent) to the threads. Torque to 4.5 N·m (40 in. lb.) . If Oil Sentry™ switch is mounted to the side of crankcase, torque the switch to 12.4 N·m (110 in. lb.). Figure 11-25.

Installing and Torquing Breather Cover/Screws. 6. Install and torque the four breather cover hex flange screws to 7.3 N·m (65 in. lb.) in the sequence shown in Figure 11-26. crankcase (vacuum fuel pump), apply pipe sealant with Teflon ® (Loctite ® 59241 or equivalent) to the threads of the fitting and install. With the crankcase upright, the fitting must point to the 1:30 position. See Figure 11-28. 11.9 Figure 11-27. Oil Sentry™ Switch Installed. 11