Section 11 Reassembly Valve Stem Seals Figure 11-28. Crankcase Vacuum Fitting Position. Figure 11-30. Cylinder Head Showing Intake Seal. Install Hydraulic Lifters 1. Lubricate the lifters and lifter bores in the crankcase with engine oil. Assemble Cylinder Heads Prior to installation, lubricate all components with engine oil, paying particular attention to the lip of the valve stem seal, valve stems and valve guides. Install the following items in the order listed below using a valve spring compressor. See Figures 11-31 and 11-32. NOTE: Hydraulic lifters should always be installed in the same position as before disassembly.
Valve stem seals Intake and exhaust valves Valve spring caps Valve springs Valve spring retainers Valve spring keepers 2. Install the lifters into their respective lifter bores according to location and cylinder number marked during assembly. See Figure 11-29. Figure 11-29. Installing Lifters. Figure 11-31. Disassembled Head and Valve Components. Valve Stem Seals NOTE: These engines use valve stem seals on the intake and exhaust valves. Always use a new seal before valves are installed in the cylinder head. Also, replace the seals if they are deteriorated or damaged in any way. Never reuse an old seal. See Figure 11-30. 11.10