Section 11 Reassembly Figure 11-32. Assembling Valves with a Valve Spring Compressor. Figure 11-34. Installing Cylinder Head. Install Cylinder Heads 1. Check to make sure there are no nicks or burrs on the sealing surfaces of the cylinder head or crankcase. 5. Install a plain washer onto each stud and secure with a hex flange nut. 6. Torque the four hex flange nuts in two steps, first to 16.9 N·m (150 in. lb.) and then to 33.9 N·m (300 in. lb.) , using the torque sequence shown in Figure 11-36. 2. Rotate the crankshaft to position the piston in cylinder #1 to top dead center (TDC) on the compression stroke. 3. Install a new cylinder head gasket. See Figure 11-33. NOTE:
Match numbers embossed on cylinder heads and crankcase. Figure 11-35. Torquing Cylinder Head Nuts. 11 Figure 11-33. Installing Head Gasket. 4. Install the #1 cylinder head onto the #1 side mounting studs. See Figure 11-34. 11.11