Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly 2. Apply grease to the contacting surfaces of the rocker arms and rocker arm pivots. Install the rocker arms and rocker arm pivots on the cylinder head. 3 1 3. Install two new hex flange rocker arm screws with Dri-Loc ® thread locking compound on the threads. Torque the screws to 11.3 N·m (100 in. lb.) . When tightening, use a steady motion, without interruption, until the proper torque is achieved. The frictional heat from the engaging threads may otherwise cause the locking compound to set prematurely. If new screws are not available, apply Loctite ® No. 242 to the bottom four or five threads. Then install and torque the screws to 11.3 N·m (100 in. lb.) .

See Figure 11-38. 4 2 #1 Cylinder Head 1 3 2 4 #2 Cylinder Head Figure 11-36. Cylinder Head Torque Sequence. 7. Repeat the installation procedure for the #2 side cylinder head. Install Push Rods and Rocker Arms 1. Note the mark or tag identifying the push rod as either intake or exhaust for cylinder #1. Lightly apply engine oil or grease to the ends of push rods and install. Make sure that each push rod ball seats in its respective hydraulic lifter socket. See Figure 11-37. Figure 11-38. Installing and Torquing Rocker Arm Mounting Screws. 4. Use a spanner wrench or rocker arm lifting tool (see Section 2) to lift the rocker arms and position the push rods underneath. NOTE:

Push rods must always be installed in the same position as before disassembly. 5. Rotate the crankshaft so the piston in cylinder #2 is at top dead center on the compression stroke, and repeat the steps for the remaining cylinder. Do not interchange parts from one cylinder head with parts from the other cylinder head. 6. Rotate the crankshaft to check for free operation of the valve train. Check the clearance between valve spring coils at full lift. The minimum allowable clearance is 0.25 mm (0.010 in) . Install Valve Covers 1. Make sure the sealing surfaces of cylinder heads and valve covers are clean and free of all old gasket material. Figure 11-37. Installing Push Rods. 11.12