Section 11 Reassembly 2. Install new valve cover gaskets onto the valve covers. See Figure 11-39. Figure 11-41. Installing Coolant Drain Plugs. Figure 11-39. Installing Valve Cover Gaskets. Install Water Pump, Drive Belt, and Transfer Tube Assembly 1. Remove the seal protector and/or protective tape (if used) from over the keyway and make sure the end of the camshaft is clean and free of any nicks or damage. Install and fully seat the key, squarely into the keyway. Be careful not to contact the camshaft seal. Test fit the cam pulley onto the shaft and key; it must slide on without force or restriction . Remove the pulley. See Figures 11-42 and 11-43. 3.
Install the valve covers with gaskets in their original locations. 4. Install the lower two mounting screws in each cover, and finger tighten only. Upper screws will be installed later. See Figure 11-40. NOTE: A mark or dot of paint applied to the top, of the pulley, indicating the keyway location, will make installation easier. Figure 11-40. Installing Valve Covers. Reinstall Coolant Drain Plugs 1. Reinstall the brass coolant drain plugs in the sides of the crankcase, (and also the cylinder head plugs, if removed during head servicing). Apply pipe sealant with Teflon ® (Loctite ® 59241 or equivalent) to the threads and reinstall the plugs. Torque the plugs to 13.5 N·m (120 in. lb.) .
See Figure 11-41. Figure 11-42. Installing Camshaft Key into Keyway. 11.13 11