Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly 5. Connect the wire leads to the temperature warning switch, audible alarm, and/or Oil Sentry™ switch as equipped. If the thermostat and thermostat housing were removed from the intake manifold, reassemble them at this time. 6. Make sure the sealing surfaces of housing and manifold are clean and free of nicks or damage. 7. Install the thermostat into the recess in the intake manifold, so the larger spring end is down . Place a new thermostat housing gasket onto the manifold surface, aligning the screw holes. Make sure that one of the notches in the gasket is aligned with the by-pass slot in the manifold and the thermostat housing. Do not use a substitute gasket.

See Figure 11-60. Figure 11-61. Torquing Thermostat Housing Screws. 9. Apply rubber lubricant to the inside end of the upper radiator hose, and install the hose to the thermostat housing, if separated for servicing. Secure with the clamp. Make sure tangs of clamp point toward the #1 cylinder, away from the fan. Install Coolant By-pass Hose (If separated from intake manifold through individual component servicing) 1. If the connector fitting for the by-pass hose was removed from the manifold, reinstall it at this time. Apply pipe sealant with Teflon ® (Loctite ® 59241 or equivalent) onto the threads and tighten, so the fitting faces/points toward the #2 side, long intake manifold screw.

Figure 11-60. Installing Thermostat and Gasket. 2. Attach the coolant by-pass hose to the fittings in the water pump and intake manifold. Secure with the clamps. 8. Position the thermostat housing on the gasket and intake manifold. The notch in manifold, gasket and thermostat housing must all be aligned. Install and torque the two hex flange screws to 9.9 N·m (88 in. lb.) . See Figure 11-61. Figure 11-62. Installing the By-pass Hose. 11.18