Section 11 Reassembly NOTE: Before installing the flywheel make sure the crankshaft taper and flywheel hub are clean, dry, and completely free of lubricants. The presence of lubricants can cause the flywheel to be overstressed and damaged when the hex flange screw is torqued to specifications. NOTE: Always use a flywheel strap wrench or holding tool to hold the flywheel when tightening the flywheel fastener. Do not use any type of bar or wedge to hold the flywheel, as component damage and personal injury could result. Figure 11-68. Installing Flywheel. 1. Install the woodruff key into the keyway of the crankshaft. Make sure that the key is properly seated and parallel with the shaft.
See Figure 11-67. 3. Install the hex flange screw and washer. See Figure 11-69. NOTE: Make sure the flywheel key is installed properly in the keyway. The flywheel can become cracked or damaged if the key is improperly installed. Figure 11-69. Installing Flywheel Mounting Hardware. Figure 11-67. Installing Key in Flywheel End of Crankshaft. 4. Use a flywheel holding tool to hold the flywheel and torque the hex flange screw to 66.4 N·m (49 ft. lb.) . See Figure 11-70. 2. Thread the two starter mounting bolts into the hub of flywheel, or use the flywheel puller to serve as a "handle" and set the flywheel in place. See Figure 11-68. Figure 11-70. Torquing Flywheel Bolt. 11.20