Section 11 Reassembly Figure 11-74. Wiring and Harness in Clamp on #1 Side. Figure 11-76. Torquing Starter Bolts. Install Spark Plugs 1. Use new Champion ® RC14YC (Kohler Part No. 66 132 01-S ) or equivalent spark plugs. 3. Attach the leads to the appropriate starter solenoid terminals. See Figure 11-77. 2. Set the spark plug gap to 0.76 mm (0.030 in.). 3. Install the plugs and torque to 24.4-29.8 N·m (18-22 ft. lb.). See Figure 11-75. Figure 11-77. Connecting Starter Leads to Starter. 4. To avoid damage or breakage, do not over- tighten the hex flange nut when attaching the positive battery cable. Torque the nut to 6-9 N·m (53-79 in. lb.) . Figure 11-75. Installing Spark Plug.
Install Starter Assembly 1. Mount the starter to the adapter plate using the two hex flange screws. NOTE: The stator leads and rectifier-regulator plug must be above the starter. 2. Make sure the starter is square to the flywheel, and torque the two hex flange screws to 15.3 N·m (135 in. lb.) . See Figure 11-76. 11.22