Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly Install Carburetor and Adapter 1. If separated, install the breather tube to breather cover as shown in Figure 11-78. Figure 11-80. Torquing Carburetor Mounting Screws. Figure 11-78. Breather Hose Installed onto Breather Cover. 2. Install the carburetor gasket on the intake manifold. See Figure 11-79. Figure 11-81. Torquing Carburetor Mounting Bolts. 4. If the adapter was separated from the carburetor, install a new gasket and mount the adapter with the breather hose connection port facing the rear. Install and torque the mounting screws to 7.3 N·m (65 in. lb.) . Figure 11-79. Installing Carburetor Gasket on Intake Manifold. 3.

Attach the longer ends of the throttle linkage and spring to the carburetor (if disconnected previously), then install the carburetor onto the intake manifold. Install and torque the two mounting screws to 6.2-7.3 N·m (55-65 in. lb.) . See Figures 11-80 and 11-81. Figure 11-82. Installing Carburetor Breather Adapter. 11.23 11