Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly 5. Connect the upper end of the breather hose to the fitting on the rear of the adapter. See Figure 11-82. 6. Connect the long end of the choke linkage to carburetor as shown in Figure 11-83. Figure 11-85. Installing/Connecting Governor Linkage. 2. Move the governor lever TOWARDS the carburetor as far as it will go (wide open throttle) and hold in this position. Figure 11-83. Connecting Choke Linkage. 7. If a mechanical fuel pump is used, install the fuel line between the outlet of the fuel pump and the carburetor inlet, and secure with the clamps. See Figure 11-84. 3.

Insert a nail into the hole in the cross shaft and rotate the shaft COUNTERCLOCKWISE as far as it will turn. Then torque the hex nut to 6.8 N·m (60 in. lb.) . See Figure 11-86. Figure 11-84. Connecting Fuel Line (Mechanical Fuel Pump). Figure 11-86. Setting Governor and Tightening Nut. 4. Connect the choke lever of the main control bracket to the choke linkage from the carburetor. Mount the main control bracket to the cylinder heads with the four screws. Torque the screws to 10.7 N·m (95 in. lb.) into new holes, or 7.3 N·m (65 in. lb.) into used holes. See Figure 11-87. Install External Governor Controls and Main Control Bracket 1. Install the governor lever onto the governor cross shaft.

If separated, connect the throttle link to governor lever with the plastic bushing. Hook the dampening spring into the small (middle) hole. 11.24