Section 11 Reassembly Install Lower Crankshaft Pulley, Pulley Adapter, and Cooling Fan Assembly 1. Make sure the shoulder of the flywheel hub and the adjacent face surface are clean and free of any nicks or damage. 2. Install the crankshaft pulley adapter onto the flywheel hub, so the offset for the pulley is out, and the holes are aligned. Make sure the adapter rests squarely on the face of the flywheel. See Figure 11-89. Figure 11-87. Installing Main Throttle Bracket. 5. Connect the dampening spring to the throttle lever as shown. Hook the governor spring from the throttle control bracket in the appropriate governor lever hole, as indicated in the chart below.
Note that the hole positions are counted from the pivot point of the governor lever. See Figure 11-88. Figure 11-89. Lower Adapter on Flywheel. 3. Assemble the front and rear pulley halves placing the shims as indicated. a. For a new belt: Assemble with two or three shims between the pulley halves, and remaining shim (if any) on the outside (front) of the outer pulley half. b. For a used belt: Assemble with two shims between the pulley halves and remaining shim(s) on the outside (front) of the outer pulley half. Figure 11-88. Governor/Throttle Linkage Connection Details. 11 Governor Spring Chart Install and snug the pulley assembly. See Figures 11-90 and 11-91.
Final belt tension and pulley assembly will be made after fan/upper pulley assembly is installed. 11.25 High Idle RPM Governor Lever Hole No. Governor Spring Color Code 3888 4 Red 3780 3 Purple 3672 3 Black 3564 3 Red 3456 2 Purple 3348 2 Green 3240 2 Red 3132 2 Clear 3024 1 Red